Lift safety operation rules

Views:962 Time:2021-10-22

1. Before use, remove the utensils and sundries that hinder the operation near the lift, and check whether the operating handle is normal. 2. The operating mechanism is sensitive and effective, and the hydraulic system is not allowed to crawl.

1. Before use, remove the utensils and sundries that hinder the operation near the lift, and check whether the operating handle is normal.

2. The operating mechanism is sensitive and effective, and the hydraulic system is not allowed to crawl.

3. When supporting the vehicle, the four supporting corners should be on the same plane, and the height of the supporting corner rubber pad should be adjusted so that it contacts the supporting parts of the vehicle chassis.

Fourth, when the vehicle is supported, the vehicle cannot be supported too high, and the four brackets should be locked after being supported.

5. After the lift vehicle drives in, the lift support block should be adjusted and moved to align with the lift point specified by the model.

6. When lifting, the personnel should leave the vehicle. When the lift reaches the required height, the safety lock pin must be inserted, and the operation under the vehicle can be started after ensuring safety and reliability.

7. Except for low-guarantee and minor repair items, other cumbersome and cumbersome operations shall not be operated and repaired on the lifter.

8. The lifter shall not rise and fall frequently.

9. When supporting the vehicle, the lift should be stable and the landing should be slow.

10. It is strictly forbidden to lift the lift when someone is working.

11. If it is found that the operating mechanism is not working, the motor is out of synchronization, the bracket is not flat or the hydraulic part is leaking oil, it should be repaired in time, and no operation with illness is allowed.

12. After the operation is completed, the sundries should be removed, and the surrounding area of the lift should be cleaned to keep the site clean and tidy.

13. Regularly (six months) remove the accumulated water in the lift cylinder, and check the oil quantity. If the oil quantity is insufficient, the pressure oil of the same brand should be filled in time. At the same time, the lubrication, lift transmission gear and seam should be checked.


举升机